RFID NFC Card Reader / Detector Module Kit V3 - PN532

PN532 NFC Module Features and Specifications

• 80C51 microcontroller core with 40 Kbyte ROM and 1 Kbyte RAM
• Highly integrated analog circuitry to demodulate and decode responses
• Buffered output drivers to connect an antenna with minimum number of external components
• Integrated RF level detector
• Integrated data mode detector
• RFID reader/writer mode support [MIFARE 1k, 4k, Ultra light, and DESFIRE cards, ISO/IEC 14443-4 cards such as CD97BX, CD light, DESFIRE, P5CN072 (SMX),  INNOVISION Jewel cards such as IRT5001 card, FELICA cards such as RCS_860 and RCS_854]
• Built in PCB Antenna, with 5cm to7cm communication distance
• Supports MIFIRE higher transfer speed communication at 212Kbits/s and 424 Kbits/s
• Supported host communication: SPI Interface, I2C Interface and High Speed Serial UART
• Flexible interrupt using IRQ pin
• Hard reset with low power function
• Power down mode per embedded firmware
• Automatic wake up on HSU,I2C and SPI interfaces when device is in power down mode
• Programmable timer
• Contactless communication at 13.56MHz
• On-board level shifter, Standard 5V TTL for I2C and UART, 3.3V TTL SPI
• Work as RFID reader and writer
• Work as RFID card or  a virtual card
• Operating  voltage: +2.7V to +5.5V
• On-board level shifter: Standard 5V TTL for I2C and UART, 3.3V TTL SPI
• Low power modes: Hard-Power-Down mode (1µA typical), Soft-Power-Down mode (22µA typical)
• Operating temperature: -30ºC to +85ºC

Kit Included:

1x PN532 NFC RFID Module

1x 2.54mm spacing 4pin Cable

1x Mifare One S50 White Card

1x Mifare One S50 Key Card

1x 12P bended male pins

Library Files: Adafruit PN532